Arch Linux ARM Pogoplug v2 (Pink/Gray) Overview and Installation The Pogoplug v2 is the second device from CloudEngines to feature Pogoplug software. Will not be responcible for any or all issues. Warning: do this at your own risk, There are several models of the pogoplug.and this only works on one version only of the unit. Once you finish the install, you may want to add other software to make the unit more usable. In case you can not get the ndisrapper module: Get kernel version # uname -a Append the kernel version to apt-get linux-headers- # apt-get install linux-headers-3.2.0-4-686-pae Get ndissrapper source # apt-get install ndiswrapper-source #apt-get remove Remove the kernel setup and then reinstall # apt-get remove ndiswrapper-dkms # apt-get install ndiswrapper-dkms You should see it being isntalled to the kernel. Tx excessive retries:0 Invalid misc:0 Missed beacon:0įrom here you should be able to configure your card. Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Link Quality:0 Signal level:0 Noise level:0 Mode:Managed Frequency:2.412 GHz Access Point: Not-Associatedīit Rate:54 Mb/s Tx-Power:10 dBm Sensitivity=0/3 Install wifi card driver (driver will usually be a. Wlan1: mtu 1500 qdisc pfifo_fast state DORMANT qlen 1000 $ sudo apt-get install ndiswrapper-common ndiswrapper-utils-1.9 ndiswrapper-dkmsĠ0:0b.0 Network controller: Texas Instruments ACX 111 54Mbps Wireless Interface Set up a legacy mswindows wifi card in linux.(Make sure your card was installed properly while the machine was off.)ĭownload and extract the mswindows drivers for the cardįw1130.bin FwRad17.bin radio17.bin TNET1130.INFįwRad16.bin radio16.bin tnet1130.cat tnet1130.sys I downloaded the MSWindows driver and in minutes the card was usuable. Linux did not have the drivers, but it did see the cards in hardware listings. Had some old wifi cards in the closet that I wanted to use for a Honeypot server. Generally linux has drivers for everything known to man, but becuase of proprietary interference or hardware is not used anymore, you may still be able to get it working. Step 18 Capture the command line or ascii movies. Step 12: Firefly Step 13: Yet another music server. Step 10: Web and the command line working together. Step 8: Create animated gifs easily Step 9: Openwrt Chilli hotspot. Step 6: Pogoplug V2 Step 7: Network printing. Step 5: Couple of simple simple command line clocks. Step 2: Message of the day, Step 3: Library conflicts. Step 1: Install an MsWindows driver on linux. I have tried to keep each of them to one step. Just a few quickie ideas I put togethr that might be of interest.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |